Disassembly/Repair of the mobile device Apple Watch Series 1 (Apple Watch Series 1 A1802, A1803) with each step description and the required set of tools.

⚠️ Before disassembling, do not forget to turn your watch off.

⚠️ Pay attention! Disassembly has a maximum 3rd difficulty because the process begins with the disassembly of the display module. If you have no experience or are not sure of your skills, we strongly recommend that you contact a specialized service center.

We recommend using a special heating device such as a separator machine, heat gun, or heating mat. It will simplify the process. You can use a home hairdryer, but you will have to make a nozzle by hand or have a suitable one in the kit to gently heat and concentrate the heat flow in the right place.

ℹ️️ The surface of the display module must be heated to soften the adhesive underneath. The approximate heating temperature is 50° C / 125° F.

ℹ️️ The module is glued not only along the contour to the housing or case but also in the middle, so keep in mind it.

Use a thin plastic film or pick for separation. To facilitate the process, you can use isopropyl alcohol. It is often most difficult to pass the tool between the parts to be divided. Choose the far edge from the FFC cables or buttons.

Do not use a lever or any force for separation that could damage the elements inside. The process can be seen in our video entirely so as well as in detail, at the end of the instructions.

⚠️ It is important not to get a film between the touchscreen/glass and the display module, this will damage the module.

⚠️ Look in advance at the picture of the places where the touchscreen and display cables pass under the display module to avoid accidental damage.

Remove the bracket securing connectors.

Disconnect the connectors and remove the cover.

Remove the battery. The battery is glued with adhesive tape so do it carefully.

In the housing remains a vibration motor.