Disassembly/Repair of the mobile device Doogee S60 IP68 with each step description and the required set of tools.
Views
Likes
Share
Questions
Step 1.
Using a screwdriver (flat), unscrew the 2 bolts in the back cover. Open the cover hiding the holders of the SIM and MMC cards.
Step 2.
Using a screwdriver (Phillips 1.5 mm PH000), unscrew 2 bolts.
Step 3.
Using a screwdriver (hex T5 or hex T6), unscrew 6 bolts on the edges of the phone and remove the frames and button keys.
Step 4.
Using a screwdriver (hex T5 or hex T6), unscrew 4 bolts in the back cover.
Step 5.
Using a screwdriver (hex T5 or hex T6), unscrew 8 bolts in the back cover.
Step 6.
Open the back cover.
Step 7.
Using a screwdriver (Phillips 1.5 mm PH000), unscrew 2 bolts and remove the bracket holds the connector.
Step 8.
Pry up the fingerprint sensor connector.
Step 9.
Using a screwdriver (Phillips 1.5 mm PH000), unscrew 4 bolts in the lower PCB.
Step 10.
Disconnect connectors on the lower PCB.
Step 11.
Remove the lower PCB.
Step 12.
Pry up the sensor.
Step 13.
Using a screwdriver (Phillips 1.5 mm PH000), unscrew 4 bolts.
Step 14.
Disconnect connector on the PCB and remove the front (selfie) camera.
Step 15.
Using a screwdriver (Phillips 1.5 mm PH000), unscrew 4 bolts in the PCB.
Step 16.
Overturn the board, disconnect the connectors from the inside.
Step 17.
Remove the PCB.
Step 18.
Unstick and remove the battery.
Step 19.
Parts are in the frame of the display module.
If you have a question, ask us, and we will try to answer in as much detail as possible. If this article was helpful for you, please rate it.
Views
Likes
Share
Questions