Disassembly/Repair of the mobile device Huawei Mediapad T10s (Huawei Mediapad T10s (AgassiR-W09A aka AGS3-W09(Wi-Fi only)), AGS3-L09 (Wi-Fi/LTE)) with each step description and the required set of tools.

⚠️️ Before disassembling, do not forget to turn your phone off.

Use the ejection tool (aka Needle) or Paperclip. Push the tip all the way into the hole until the tray ejects, and then pull the tray of SIM and Memory card (Micro SD) out.

⚠️️ Pay attention! The tool must be inserted into a hole on the edge of the phone's housing. Do not press too hard. It may break the tray eject mechanism.

⚠️️ Pay attention! Disassembly has a maximum 3rd difficulty because the process begins with the disassembly of the display module. If you have no experience or are not sure of your skills, we strongly recommend that you contact a specialized service center.

It will simplify the process. You can use a home hairdryer, but you will have to make a nozzle by hand or have a suitable one in the kit to gently heat and concentrate the heat flow in the right place.

ℹ️️ The surface of the display module must be heated to soften the adhesive underneath. The approximate heating temperature is 50° C / 125° F.

Use a thin plastic film or pick for separation. To facilitate the process, you can use isopropyl alcohol. It is often the most difficult to pass the tool between the parts to be divided. Choose the far edge from the FFC cables or buttons.

Do not use a lever or any force for separation that could damage the elements inside.

The process can be seen in our video entirely so as well as in detail, at the end of the instructions.

Using a screwdriver (Phillips 1.5 mm PH000), unscrew two screws and remove the brackets holding the connectors.

Disconnect the battery connector as soon as possible. It is better to use a non-metal or plastic tool to avoid any damage.

ℹ️️ The Huawei MediaPad T10s model has a battery HB2899C0ECW-C with 5000 mAh capacity (aka rechargeable battery).

⚠️️ It is highly recommended to disconnect the connector to avoid possible short circuits during disassembly.

Also, try not to use a metal tool to disconnect the rechargeable battery connector or do it carefully.

Pry up the connector and remove the display module.

Using a screwdriver (Phillips 1.5 mm PH000), unscrew one screw and remove the bracket holding the rear camera.

Using a screwdriver (Phillips 1.5 mm PH000), unscrew 43 silver screws.

Using a screwdriver (Phillips 1.5 mm PH000), unscrew two black screws.

Pry over the edges and remove the middle frame.

Remove the bracket holding the charging port.

Disconnect the connector and remove the loudspeaker.

Pry up the connector and remove the second loudspeaker.

Carefully remove the printed circuit board. There is no need to use a lever or try to reach the circuit board by force. Make sure that nothing is getting in the way or holding the circuit board.

The motherboard, also, may be attached with attachments like latches or hooks, be careful.

⚠️️ Do not bend the circuit board when removing it or push tools under it. Unbeknownst to yourself, you can damage components or cables from the inside.

Pry up the connector and remove the rear camera.

Pry up the connector and remove the front (selfie) camera.

⚠️️ The camera is glued from the inside with an adhesive tape to the motherboard, so be careful.

ℹ️️ In the housing remained: the battery.