Recommended tools
Heat gun
Screwdriver Torx T5
Opening tool / Spudger
Tweezers
Disassembly/Repair of the mobile device Motorola DROID Turbo XT1254 (Motorola XT1254) with each step description and the required set of tools.
7704
Views
0
Likes
—
Share
3
Questions
Step 1.
Remove the tray
Using the key tool, open the SIM card slot and remove it.
âš Warning!
Do not push too hard this may cause damage.
Step 2.
Open the back cover
Open the back cover.
âš Warning!
For careful separation, we recommend using a heat gun. At the same time, it is necessary to heat carefully in order, not to damage the surface of the device.
Step 3.
Open the mid-frame
Pry and remove the middle frame.
Step 4.
Unscrew the screws
Using a screwdriver (hex T5), unscrew 4 bolts in the upper part.
Step 5.
Remove the antenna
Remove the upper panel with antennas.
Step 6.
Unscrew the screws
Using a screwdriver (hex T5), unscrew 4 bolts in the lower part.
Step 7.
Remove the frame
Remove the lower part.
Step 8.
Remove the front camera
Disconnect the connector on PCB and remove the front (selfie) camera.
Step 9.
Disconnect the connector
Disconnect the connector on the PCB.
âš Warning!
The connector located on the inside.
Step 10.
Remove the motherboard
Remove the PCB.
Step 11.
In the display frame remained
Parts in the frame of the display module.
If you have a question, ask us, and we will try to answer in as much detail as possible. If this article was helpful for you, please rate it.
7704
Views
0
Likes
—
Share
3
Questions
Related Instructions
Related Reviews
Related Blog
Top instructions
Check our
Top Motorola instructions most liked by readers
New instructions
Check our
New Motorola brand instructions on vrm24.com
