Disassembly/Repair of the mobile device Samsung Galaxy J6 (2018) SM-J600 (Samsung Galaxy J6 (2018) J600F/DS (Global DS); J600G/DS (India) & Samsung Galaxy On6) with each step description and the required set of tools.

⚠️️ Pay attention! Disassembly has a maximum 3rd difficulty because the process begins with the disassembly of the display module. If you have no experience or are not sure of your skills, we strongly recommend that you contact a specialized service center.

It will simplify the process. You can use a home hairdryer, but you will have to make a nozzle by hand or have a suitable one in the kit to gently heat and concentrate the heat flow in the right place.

ℹ️️ The surface of the display module must be heated to soften the adhesive underneath. The approximate heating temperature is 50° C / 125° F.

Use a thin plastic film or pick for separation. To facilitate the process, you can use isopropyl alcohol. It is often the most difficult to pass the tool between the parts to be divided. Choose the far edge from the FFC cables or buttons.

Do not use a lever or any force for separation that could damage the elements inside.

The process can be seen in our video entirely so as well as in detail, at the end of the instructions.

Using a screwdriver (Phillips 1.5 mm PH000), unscrew 19 screws.

Pry over the edges. Move an opening tool along the edge detach the clips and separate the middle cover from the housing.

Try to lift the cover by the edges and don't push anything too far inside, so as not to accidentally break or short-circuit anything on the circuit board.

Disconnect the battery connector as soon as possible. It is better to use a non-metal or plastic tool to avoid any damage.

ℹ️️ The Samsung Galaxy J6 (2018) SM-J600 model has a battery EB-BJ800ABE with 3000 mAh capacity (aka rechargeable battery).

⚠️️ It is highly recommended to disconnect the connector to avoid possible short circuits during disassembly.

Also, disconnect the headphone jack socket connector.

Disconnect the connector on the motherboard and remove the front (selfie) camera.

Using a screwdriver (Phillips 1.5 mm PH000), unscrew two screws securing the motherboard.

Carefully remove the printed circuit board. There is no need to use a lever or try to reach the circuit board by force. Make sure that nothing is getting in the way or holding the circuit board.

The motherboard, also, may be attached with attachments like latches or hooks, be careful.

⚠️️ Do not bend the circuit board when removing it or push tools under it. Unbeknownst to yourself, you can damage components or cables from the inside.

Pry over the edge and remove the assembly with a headphone jack socket and microphone.

ℹ️️ In the middle cover remained: the earpiece speaker, loudspeaker, battery.