Disassembly/Repair of the mobile device Samsung Galaxy J7 (2017) SM-J730 (Samsung J730F/DS (Global Dual-SIM); J730FM/DS (UAE, Russia)) with each step description and the required set of tools.

Use the ejection tool (aka Needle) or Paperclip. Push the tip all the way into the hole until the tray ejects, and then pull the tray out. Should do it for each of the SIM and Memory card (Micro SD) trays.

⚠️️ Pay attention! The tool must be inserted into a hole on the edge of the phone's housing. Do not press too hard. It may break the tray eject mechanism.

⚠️️ Pay attention! Disassembly has a maximum 3rd difficulty because the process begins with the disassembly of the display module. If you have no experience or are not sure of your skills, we strongly recommend that you contact a specialized service center.

It will simplify the process. You can use a home hairdryer, but you will have to make a nozzle by hand or have a suitable one in the kit to gently heat and concentrate the heat flow in the right place.

ℹ️️ The surface of the display module must be heated to soften the adhesive underneath. The approximate heating temperature is 50° C / 125° F.

Use a thin plastic film or pick for separation. To facilitate the process, you can use isopropyl alcohol. It is often the most difficult to pass the tool between the parts to be divided. Choose the far edge from the FFC cables or buttons.

Do not use a lever or any force for separation that could damage the elements inside.

The process can be seen in our video entirely so as well as in detail, at the end of the instructions.

Pry over the edge and remove the bracket holding display connector.

Disconnect the connector and remove the display module.

Using a screwdriver (Phillips 1.5 mm PH000), unscrew 17 screws .

Using a spudger or a plastic pick, carefully, around the edge, detach the back cover clips, and remove it.

Do not insert the tool deeply or bend it. Otherwise, the housing may be tampered with or damaged.

⚠️️ Be careful when opening the cover from the volume and power buttons side. Thin cable and fragile buttons are straightforward to damage.

Disconnect the battery connector as soon as possible. It is better to use a non-metal or plastic tool to avoid any damage.

ℹ️️ The Samsung Galaxy J7 (2017) SM-J730 model has a battery EB-BA720ABE with 3600 mAh capacity (aka rechargeable battery).

⚠️️ It is highly recommended to disconnect the connector to avoid possible short circuits during disassembly.

Also, disconnect connector of underscreen cable.

Disconnect the connector on the motherboard, and remove the front (selfie) camera.

Using a screwdriver (Phillips 1.5 mm PH000), unscrew two screws securing the motherboard.

Carefully remove the printed circuit board. There is no need to use a lever or try to reach the circuit board by force. Make sure that nothing is getting in the way or holding the circuit board.

The motherboard, also, may be attached with attachments like latches or hooks, be careful.

⚠️️ Do not bend the circuit board when removing it or push tools under it. Unbeknownst to yourself, you can damage components or cables from the inside.

Using a screwdriver (Phillips 1.5 mm PH000), unscrew 3 screws securing the loudspeaker.

Pry carefully over the edge and remove the loudspeaker.

ℹ️️ In the middle frame: the earpiece speaker, battery, and vibration motor.

In the housing remained: