Disassembly/Repair of the mobile device Sony Xperia Z5 (Sony Xperia Z5 E6603) with each step description and the required set of tools.

⚠ Before disassembling, do not forget to turn your phone off.

Open the protective plug/hatch hiding the SIM cards tray. Using fingers or tweezers, pull the tray out.

We recommend using a special heating device such as a separator machine, heat gun, or heating mat. It will simplify the process. You can use a home hairdryer, but you will have to make a nozzle by hand or have a suitable one in the kit to gently heat and concentrate the heat flow in the right place.

ℹ️ The surface of the back cover must be heated to soften the adhesive underneath. The approximate heating temperature is 50° C / 125° F.

Use a thin plastic film or pick for separation. To facilitate the process, you can use isopropyl alcohol. It is often most difficult to pass the tool between the parts to be divided. Choose the far edge from the FFC cables or buttons.

Do not use a lever or any force for separation that could damage the elements inside.

Disconnect the battery connector as soon as possible.

ℹ️ The Sony Xperia Z5 E6603 model has a battery LIS1593RPC with 2900 mAh capacity (aka rechargeable battery).

⚠ It is highly recommended to disconnect the connector to avoid possible short circuits during disassembly.

Also, try not to use a metal tool to disconnect the rechargeable battery connector or do it carefully.

With extreme care removing the battery that is glued from the inside, moreover under which there are several cables.

Using a screwdriver (Philips 1.5 mm PH000), unscrew two screws.

Remove the bracket securing the cable with contacts for the loudspeaker and vibration motor.

Bend the cable with a vibration motor in the opposite direction to give access to the loudspeaker. 

Remove the loudspeaker assembly with antennas.

Pry up the cables' connectors for the display module, microphone, charging port, the upper one fingerprint sensor, loudspeaker, vibration motor. 

⚠ Be careful when removing the cables from the connectors, the cables are pretty thin, and it is easy enough to break them or damage the contact tracks inside.

Using a screwdriver (Philips 1.5 mm PH000), unscrew two screws and remove the cover.

Pry up the connector and remove the rear camera.

Disconnect the headphone jack socket connector.

Bend the cable with a headphone jack connector to expose one screw. Using a screwdriver (Philips 1.5 mm PH000), unscrew this one screw and remove the cover with antennas.

Pry up the connector and remove the front (selfie) camera.

Carefully remove the printed circuit board. There is no need to use a lever or try to reach the board by force. Make sure that nothing is getting in the way or holding the board.

⚠ Do not bend the circuit board when removing it or push tools under it. Unbeknownst to yourself, you can damage components or cables from the inside.

Carefully remove the charging port and microphone.

ℹ️ In the housing remained: the earpiece speaker, headphone jack socket.