Disassembly/Repair of the mobile device Xiaomi Pocophone F1 (Xiaomi Pocophone F1 M1805E10A) with each step description and the required set of tools.

Use the ejection tool (aka Needle) or Paperclip. Push the tip all the way into the hole until the tray ejects, and then pull the tray of SIM and Memory card (Micro SD) out.

⚠️ Pay attention! The tool must be inserted into a hole on the edge of the phone's housing. Do not press too hard. It may break the tray eject mechanism.

Using a screwdriver (hex T2), unscrew 2screws at the end of the phone.

Using a spudger or a plastic pick, carefully, around the edge, detach the back cover clips, and remove it.

Do not insert the tool deeply or bend it. Otherwise, the housing may be tampered with or damaged.

⚠️ Be careful when opening the cover from the volume and power buttons side. Thin cable and fragile buttons are straightforward to damage.

Using a screwdriver (Phillips 1.5 mm PH000), unscrew 8 screws.

Using a screwdriver (Phillips 1.5 mm PH000), unscrew 2 short white screws.

Remove the cover with antennas. The cover protects the printed circuit board (PCB). Try to lift the cover by the edges and not push anything between them to not accidentally touch or short-circuit anything on the circuit board.

Also, the cover holds the fingerprint sensor connector, but the fingerprint sensor itself is located on the back cover and connected to the motherboard via a flat cable.

Disconnect the fingerprint sensor connector and remove the back cover.

Peel back the protective film.

Disconnect the connectors and remove the two front (selfie) cameras. The cameras are covered with copper film (passive heat sink).

Using a screwdriver (Phillips 1.5 mm PH000), unscrew 5 short screws.

Using a screwdriver (Phillips 1.5 mm PH000), unscrew 2 long screws.

Pry over the edge and remove the loudspeaker assembly with antennas.

Pry up the coaxial cable connector.

Carefully, preferably from the edge, disconnect the connectors and remove the inter-board cable connecting the mainboard to the daughterboard (also known as the sub-board).

⚠️ Be careful when removing the cables from the connectors, the cables are pretty thin, and it is easy enough to break them or damage the contact tracks inside.

ℹ️ An arrow on the FFC cable (flexible flat cable) indicates its correct position.

Remove the sub-board. It may be glued to the frame with metalized tape, so to facilitate the process, the sub-board can be heated a bit.

The sub-board, also, may be attached with attachments like latches or hooks, be careful.

ℹ️ The sub-board contains a charging port (Micro-USB), microphone, spring contacts for the speaker, vibration motor, and an antenna unit.

⚠️ It is not necessary to insert the tool underneath when removing the sub-board. Internal components could be damaged.

Pry up the connectors of power volume buttons cable, display module cable, and coaxial cable.

⚠️ Be careful when removing the cables from the connectors, the cables are pretty thin, and it is easy enough to break them or damage the contact tracks inside.

Using a screwdriver (Phillips 1.5 mm PH000), unscrew two screws securing the motherboard. 

Carefully remove the printed circuit board. There is no need to use a lever or try to reach the circuit board by force. Make sure that nothing is getting in the way or holding the circuit board.

The motherboard, also, may be attached with attachments like latches or hooks, be careful.

⚠️ Do not bend the circuit board when removing it or push tools under it. Unbeknownst to yourself, you can damage components or cables from the inside.

Disconnect connectors on motherboard and remove the assembly of two rear cameras.