Using the key tool, open the SIM card and MMC card trays and remove it.
Do not push too hard this may cause damage.
Unstick the covers hide the bolts.
For careful separation, we recommend using a heat gun. At the same time, it is necessary to heat carefully in order, not to damage the surface of the device.
Using a screwdriver (hex T4), unscrew 4 bolts securing the display module.
Separate the display and turn it over.
Disconnect connectors and remove the display.
Using a screwdriver (hex T4), unscrew 3 bolts in the lower part and disconnect the inter-board cable connector.
Remove the lower PCB.
Disconnect connectors on the PCB.
Using a screwdriver (Phillips 1.5 mm PH000), unscrew 3 bolts in the PCB.
Disconnect connector on the PCB and remove the main camera.
Remove the PCB.
Parts in the frame of the display module.