Using the key tool, open the SIM and Micro SD cards tray and remove it.
Do not push too hard this may cause damage.
Open the back cover.
For careful separation, we recommend using a heat gun. At the same time, it is necessary to heat carefully in order, not to damage the surface of the device.
Also, disconnect the fingerprint sensor connector.
Using a screwdriver (Phillips 1.5 mm PH000), unscrew 3 bolts and remove the brackets holding the connectors.
Disconnect the connector and remove the fingerprint sensor cable.
Using a screwdriver (Phillips 1.5 mm PH000), unscrew 7 bolts.
Pry and remove the middle frame.
Remove the buzzer (speaker) assembly.
Disconnect connectors on the PCB.
Remove the lower PCB.
Disconnect connectors on PCB and remove the main and front (selfie) cameras.
Remove the PCB.
Parts are in the frame of the display module.