Hello, the recommended temp is 158-178F or - / + 80C. You have to heat a surface of the cover for an adhesive tape became softer underneath. Warning! When you take off the back cover, an adhesive tape got to remain glued on side the cover it's IMPORTANT! Otherwise the layer of paint of the cover will be damaged.
Hello, the recommended temp is 158-178F or -/+ 80C. You have to heat a surface of the cover for an adhesive tape became softer underneath. Warning! When you take off the back cover, an adhesive tape got to remain glued on side the cover it's IMPORTANT! in otherwise the layer of paint of the cover will be damaged.
I don't know how it will be in Italian but I will try )
Hi, you can't just lift it with a suction cup to raise it. You have to pull the suction cup up carefully and at the same time separate the display with the opening tool.
in English, you can't just lift it up with suction cup. You have to draw the suction cup up carefully and simultaneously to separate the display with opening tool.
Hello! Can you please tell whether you found any difference on the insides of demo unit vs the real apart from the modem antenna etc ,i mean do they have the exact quality of machinery on the motherboards and sensors
Thankyou sir i now understand. Its just that we have people here who say that demo units are made to work for short period of time in the display stores untill the new model comes out.So thats why i asked you.
You have looked into these demo units so you know that their parts are made from the same quality as original phone.i hope you keep on uploading these useful videos
Good afternoon, thank you in advance for your response, can the motherboard of the demo be changed for a normal s6 edge plus? And would it work normally? Or is there something else to add?
Okay, I'm not good at Spanish. I'll copy it in English.
I met two different types of demo boards in this model. In some, the daughterboard is also a demo board and doesn't have components of the network, but there are usually ones. If with components, everything will work, it will only be necessary to put coaxial cables.
Components: all sorts of resistors, capacitors, coils and small microcircuits, filters.
But on this model, it's still bad that the touch buttons of the flexible sub-board go under the module and to replace it, you need to separate the module.
I met two different types of demo in this model. In some,
the daughterboard is also demo and doesn't have components of the
network, but there are whereas usual. If with components, then
everything will work, it will only be necessary to put coaxial
cables.
Components - all sorts of resistors capacitors, coils and small
microcircuits, filters.
But on this model, it’s still bad that the touch buttons of the
flexible sub-board go under the module and to replace it, you need to
separate the module.
Nadir Rezgui13
2017-01-10ReDragon™10
2017-05-20HOLLYWOOD elCLASSICO12
2017-12-29Aleex Ness6
2018-03-09Salim Pedraza Flores1
2018-05-16Diego Salazar3
2019-08-23