Hello, if you will use the heat gun carefully. It won't. Choose the correct temperature, 70-80C will be suitable for beginners (the low temperature helps avoid mistakes). But if you have any doubts, don't do it, let this be done by a specialist for you.
If you will use the heat gun carefully. It won't. Choose the temperature correctly, 70-80C will be suitable for novices (the low temp helps avoid mistakes ). But if you have any piece of doubt don't do it, let this be done by a specialist for you.
Hello sir, after being repaired through local sony service centre, my xa isn't assembled well. The sides are loose where display light is bleeding. Back cover is open at the side and bottom plus they refused to give me service job sheet number. So i have a doubt that service centre replaced my phone with old one.
Kindly give me some tips so i can resolve this issue.
Thank you.
vremonte24.ru Yes i think it's some kind of fraud. The statement they gave me isn't convincing. Today i went to service centre to get my back cover replaced and i told the guy there to open the back panel in front of me and there wasn't any seal that you peeled at 4:40 and there were dents on that silver thing and on the brown connector. When i enquired about it, they said it's normal if your motherboard is being replaced. It gave me another feeling that it's not my device but old. Tell me is that seal necessary there and is it normal to have dents on that thing which is under that seal?
The silver covers could be dented when the covers were lifted (or levered) off where were repair of microchips. The PCB can be replaced - if a specialist doesn't see other ways but they must give you a warranty, no doubt. I see here two contradictions - if the board was replaced, why it has repair traces. PS better stick the heat-sink-copper-layer up.
that small black cable on one side of the battery, which goes from the charging IC to the motherboard, what function does it serve? when I disassembled my phone without realizing it, it came off from the base of the board
I already noticed that x'D, I improvised a solution I had to throw away that cable, solder another one directly to the board where the piece that was torn off went and to avoid also soldering on the charging board I just put it making contact with the springs that touch the antenna (in the little black cover that comes next to the speaker), currently working at 100%
Hi.
I submitted xa in service centre due to battey issue. After collecting the device, i found that the front camera sometimes shows error and sometimes it works, to which i thought to be a software issue. So within 2 months of repair, my phone went entirely dead, so after submitting in service centre again (in warranty), the service centre dissambled the device and found that the camera module connector was cut in one side and they refused to consider camera in warranty. The excuse they gave me was that, "why didn't i informed the service centre immediately about it."
Can you suggest something or what should i do? What is the cost of the front camera module?
If the problem with the camera only and your the warranty is over and the service refuses to help you. I don't know what to do. Buy camera & replace in another service or demand solution of this case in the first one.
vremonte24.ru No there was not only camera problem. The device died within two months of repair. The device is in service centre under repair but they refused to fix the camera under warranty.
Vishnu Mohandas8
2017-09-30nar da8
2017-10-07Lizeth Silvana19
2018-01-17Ninha Ninha5
2018-01-23Sophie Schwarz1
2018-01-30Khursheede3
2018-01-31Tushar Hossain1
2018-05-06Miguel Molina4
2018-05-28Raashid Wani6
2018-08-10爸爸14
2020-11-01