Recommended tools
Soldering Iron
Screwdriver Phillips #000
Opening tool / Spudger
Tweezers
Disassembly/Repair of the mobile device DEXP Ursus Z110 (DEXP Ursus Z110/Z110i Apollo) with each step description and the required set of tools.
6430
Views
6
Likes
—
Share
3
Questions
Step 1.
Open the back cover
Open the back cover and turn it over.
Step 2.
Open the cover
Pry up the connector and remove the cover.
Step 3.
Disconnect the battery connector
Disconnect the battery connector.
âš Warning!
We strongly recommend disconnecting the connector to avoid a possible short circuit during disassembly.
Step 4.
Remove the protective film
Peel back the protective layer.
Step 5.
Remove the rear camera
Disconnect the connector on PCB, and remove the main camera.
Step 6.
Remove the coaxial cable
Pry up the coaxial cables connectors.
Step 7.
Unscrew one screw
Using a screwdriver (Phillips 1.5 mm PH000), unscrew 1 bolt in the small board.
Step 8.
Remove the small board
Remove the small board.
Step 9.
Unscrew the screws
Using a screwdriver (Phillips 1.5 mm PH000), unscrew 3 bolts in the PCB.
Step 10.
Remove the front camera
Disconnect the connectors on PCB, and remove the (FFC) cable with front-selfie camera.
Step 11.
Disconnect the connectors
Disconnect connectors on the PCB.
Step 12.
Remove the microphone
Unsolder the microphone contacts.
Step 13.
Remove the loudspeaker
Unsolder vibration motor and loud speaker contacts.
Step 14.
In the display frame remained
Parts are in the frame of the display module.
If you have a question, ask us, and we will try to answer in as much detail as possible. If this article was helpful for you, please rate it.
6430
Views
6
Likes
—
Share
3
Questions
Related Instructions
Related Reviews
Related Blog
Top instructions
Check our
Top DEXP instructions most liked by readers
New instructions
Check our
New DEXP brand instructions on vrm24.com