Disassembly/Repair of the mobile device Meizu Pro 6 Plus M686H (Meizu Pro 6 Plus M686H) with each step description and the required set of tools.

Using a screwdriver (Star Shape 0.8mm Pentalobe), unscrew the 2 bolts on the end of the phone.

Using the key tool, open the SIM card tray and remove it.

⚠ Warning!

Do not push too hard this may cause damage.

Open the back cover.

Using a screwdriver (Phillips 1.5 mm PH000), unscrew 1 bolt and remove the bracket holds the connectors.

Disconnect connectors of the inter-board connector and the battery.

⚠ Warning!

We strongly recommend disconnecting the connector to avoid a possible short circuit during disassembly.

Using a screwdriver (Phillips 1.5 mm PH000), unscrew 2 bolts and remove the bracket holds the vibration motor.

Using a screwdriver (Phillips 1.5 mm PH000), unscrew 6 bolts in the lower part.

Pry and remove the buzzer (speaker) assembly.

Using a screwdriver (Phillips 1.5 mm PH000), unscrew 2 bolts in the PCB.

Disconnect connectors on the lower PCB.

Remove the PCB and inter-board cable.

Using a screwdriver (Phillips 1.5 mm PH000), unscrew 1 bolt and remove the bracket holds the main camera.

Disconnect connector on the PCB and remove the front (selfie) camera.

Using a screwdriver (Phillips 1.5 mm PH000), unscrew 8 bolts in the PCB.

Using a screwdriver (Phillips 1.5 mm PH000), unscrew 1 non-magnetic bolt in the PCB.

Disconnect connectors on the PCB. Turn over PCB, disconnect one connector from the inside

Remove the PCB.

Pry and remove the main camera.

Parts in the frame of the display module.