Disassembly/Repair of the mobile device Huawei MediaPad M3 Lite 8" (Huawei MediaPad M3 Lite CPN-L09) with each step description and the required set of tools.

Using the key tool, open the SIM and Micro SD cards tray and remove it.

⚠ Warning!

Do not push too hard this may cause damage.

Separate the display module from the housing and turn it over.

⚠ Warning!

For careful separation, we recommend using a heat gun. At the same time, it is necessary to heat carefully in order, not to damage the surface of the device.

Using a screwdriver (Phillips 1.5 mm PH000), unscrew 1 screw and remove the bracket holding the display module connector.

Pry up the connector and remove the display module.

Using a screwdriver (Phillips 1.5 mm PH000), unscrew 2 screws.

Remove the bracket.

Disconnect the battery connector. The battery model of Huawei MediaPad M3 Lite 8'' is HB3080G1EBW.

⚠ Warning!

We strongly recommend disconnecting the connector to avoid a possible short circuit during disassembly.

Using a screwdriver (Phillips 1.5 mm PH000), unscrew 5 screws.

Remove the cover with a loudspeaker.

Using a screwdriver (Phillips 1.5 mm PH000), unscrew 1 screw.

Remove the bracket holding the charging port.

Using a screwdriver (Phillips 1.5 mm PH000), unscrew 6 screws.

Remove the cover with a loudspeaker.

Using a screwdriver (Phillips 1.5 mm PH000), unscrew 1 screw and remove the bracket holding the main camera connector.

Disconnect the connector on PCB, and remove the main camera.

Disconnect connectors on the sub-board.

⚠ Warning!

The coaxial cable connector is inside.

Remove the daughterboard, also known as sub-board.

Pry up the connector, peel back the protective layer and remove the coaxial cable.

Using a screwdriver (Phillips 1.5 mm PH000), unscrew 5 screws in the PCB.

Disconnect the coaxial cable connectors.

Remove the PCB.

Disconnect the connector on PCB, and remove the front (selfie) camera.