Recommended tools
Heat gun
Screwdriver Phillips #000
Opening tool / Spudger
Tweezers
Eject tool
Disassembly/Repair of the mobile device Lenovo Vibe Shot Z90 (Lenovo z90-7 \ Lenovo Vibe Max) with each step description and the required set of tools.
8077
Views
7
Likes
—
Share
82
Questions
Step 1.
Open the back cover
Open the back cover.
âš Warning!
For careful separation, we recommend using a heat gun. At the same time, it is necessary to heat carefully in order, not to damage the surface of the device.
Step 2.
Remove the trays
Using the key tool, open the SIM and MMC card trays and remove it.
âš Warning!
Do not push too hard this may cause damage.
Step 3.
Unscrew the screws
Using a screwdriver (Phillips 1.5 mm PH000), unscrew 11 bolts in the frame of the phone.
Step 4.
Open the mid-frame
Pry and remove the middle frame.
Step 5.
Unscrew one screw
Using a screwdriver (Phillips 1.5 mm PH000), unscrew 1 bolt and remove the protective cover.
Step 6.
Remove the battery
Disconnect connector on the PCB and remove the battery.
Step 7.
Remove the front camera
Disconnect connector on the PCB and remove the front (selfie) cameras.
Step 8.
Remove the loudspeaker
Pry and remove the buzzer (speaker) assembly.
Step 9.
Remove the vibration motor
Disconnect connectors on the PCB and pry up vibration motor.
Step 10.
Turn over the PCB
Overturn the board, disconnect the connector from the inside and remove it.
Step 11.
In the display frame remained
Parts are in the frame of the display module.
If you have a question, ask us, and we will try to answer in as much detail as possible. If this article was helpful for you, please rate it.
8077
Views
7
Likes
—
Share
82
Questions
Related Instructions
Related Reviews
Related Blog
Top instructions
Check our
Top Lenovo instructions most liked by readers
New instructions
Check our
New Lenovo brand instructions on vrm24.com
