Disassembly/Repair of the mobile device Lenovo Vibe S1 with each step description and the required set of tools.

5331

Views

—

Share

90

Questions

Vadim Popoff

Vadim Popoff

Content manager / Author / Content specialist

Content specialist with over 10 years of experience in the technology industry.

Remove the tray

Step 1.

Remove the tray

Using the key tool, open the SIM card tray and remove it.

⚠ Warning!

Do not push too hard this may cause damage.

Open the back cover

Step 2.

Open the back cover

Open the back cover.

⚠ Warning!

For careful separation, we recommend using a heat gun. At the same time, it is necessary to heat carefully in order, not to damage the surface of the device.

Remove the protective film

Step 3.

Remove the protective film

Peel back the protective layer.

Unscrew the screws

Step 4.

Unscrew the screws

Using a screwdriver (Phillips 1.5 mm PH000), unscrew 2 bolts in the protective cover.

Remove the protective film

Step 5.

Remove the protective film

Remove the protective cover.

Remove the battery

Step 6.

Remove the battery

Disconnect connector on the PCB and remove the battery.

Unscrew the screws

Step 7.

Unscrew the screws

Using a screwdriver (Phillips 1.5 mm PH000), unscrew 4 bolts in the lower parts.

Remove the loudspeaker

Step 8.

Remove the loudspeaker

Pry and remove the buzzer (speaker) assembly.

Disconnect the connectors

Step 9.

Disconnect the connectors

Disconnect connectors on the lower PCB.

Remove the motherboard

Step 10.

Remove the motherboard

Remove the PCB.

Remove the rear camera

Step 11.

Remove the rear camera

Disconnect connector on the PCB and remove the main camera.

Unscrew the screws

Step 12.

Unscrew the screws

Using a screwdriver (Phillips 1.5 mm PH000), unscrew 4 bolts in the PCB.

Disconnect the connectors

Step 13.

Disconnect the connectors

Disconnect connectors on the PCB.

Remove the sub-board

Step 14.

Remove the sub-board

Overturn the board, disconnect the connectors from the inside and remove it.

Unscrew the screws

Step 15.

Unscrew the screws

Using a screwdriver (Phillips 1.5 mm PH000), unscrew 1 bolts securing the two front (selfie) cameras.

Remove the front camera

Step 16.

Remove the front camera

Pry & remove the front cameras.

Remove the cable

Step 17.

Remove the cable

Pry up the power & volume buttons flex cable.

In the display frame remained

Step 18.

In the display frame remained

Parts are in the frame of the display module.

Evgenii Kuzmin

Evgenii Kuzmin

Senior maintenance service and repair engineer
Disassembling\Repair has medium complexity and takes about 15 minutes in time. Our manual is suitable for all models Lenovo Vibe S1 or Леново Вайб Эс1 released for markets in different countries.
#instructions #Lenovo #Lenovo Vibe S1
Detailed disassembly instructions of Lenovo Vibe S1 in the video, made by our mobile repair & service center:

If you have a question, ask us, and we will try to answer in as much detail as possible. If this article was helpful for you, please rate it.

logo

5331

Views

—

Share

90

Questions

Top instructions

Check our Top Lenovo instructions most liked by readers

New instructions

Check our New Lenovo brand instructions on vrm24.com