Disassembly/Repair of the mobile device Xiaomi Redmi 9T (Xiaomi Redmi 9T M2010J19SY) with each step description and the required set of tools.

⚠ Before disassembling, do not forget to turn your phone off.

Use the ejection tool (aka Needle) or Paperclip. Push the tip all the way into the hole until the tray ejects, and then pull the tray of SIM and Memory card (Micro SD) out.

⚠ Pay attention! The tool must be inserted into a hole on the edge of the phone's housing. Do not press too hard. It may break the tray eject mechanism.

Using a spudger or a plastic pick, carefully, around the edge, detach the back cover clips, and remove it.

Do not insert the tool deeply or bend it. Otherwise, the housing may be tampered with or damaged.

⚠ Be careful when opening the cover from the volume and power buttons side. Thin cable and fragile buttons are straightforward to damage.

⚠ Pay attention to the fingerprint sensor cable!

Using a screwdriver (Phillips 1.5 mm PH000), unscrew 9 screws.

Remove the cover that protects the printed circuit board (PCB).

Disconnect the battery connector as soon as possible.

ℹ️ The Xiaomi Redmi 9T M2010J19SY model has a battery BN62 with 6000 mAh capacity (aka rechargeable battery).

⚠ It is highly recommended to disconnect the connector to avoid possible short circuits during disassembly.

Also, try not to use a metal tool to disconnect the rechargeable battery connector or do it carefully.

Pry up the fingerprint sensor connector and remove the back cover.

Using a screwdriver (Phillips 1.5 mm PH000), unscrew 7 screws.

Remove the loudspeaker assembly with antennas.

Disconnect the coaxial cable connector, cable to the mainboard, on the daughterboard.

⚠ Do not pull on the cable or pry it with a sharp tool, the connectors are pretty weak and break easily, or the cable falls out of the end (lug).

Remove the sub-board. It is glued to the frame with metalized tape, so to facilitate the process, the sub-board can be heated a bit.

ℹ️ The sub-board contains a charging port (Micro USB), vibration motor, spring contacts for the speaker, microphone, and an antenna unit.

⚠ It is not necessary to insert the tool underneath when removing the sub-board. Internal components could be damaged.

Pry up the connectors of the display module cable, coaxial cable.

⚠ Be careful when removing the cables from the connectors, the cables are pretty thin, and it is easy enough to break them or damage the contact tracks inside.

Pry up the connectors and remove three rear cameras and one front (selfie) camera.

Carefully remove the printed circuit board. There is no need to use a lever or try to reach the board by force. Make sure that nothing is getting in the way or holding the board.

⚠ Do not bend the circuit board when removing it or push tools under it. Unbeknownst to yourself, you can damage components or cables from the inside.

Pry up the connector and remove the rear camera.