Disassembly/Repair of the mobile device BQ-6001L JUMBO with each step description and the required set of tools.
Views
Likes
Share
Questions
Step 1.
Open the back cover.
âš Warning!
For careful separation, we recommend using a heat gun. At the same time, it is necessary to heat carefully in order, not to damage the surface of the device.
Step 2.
Open the back cover.
Step 3.
Unsolder the battery wires.
âš Warning!
We strongly recommend unsoldering the wires to avoid a possible short circuit during disassembly.
Step 4.
Disconnect the connector and remove the fingerprint sensor.
Step 5.
Using a screwdriver (Phillips 1.5 mm PH000), unscrew 2 bolts and remove the bracket holds the connector.
Step 6.
Using a screwdriver (Phillips 1.5 mm PH000), unscrew 6 bolts in the lower part.
Step 7.
Pry and remove the cover.
Step 8.
Disconnect connectors on the PCB.
Step 9.
Remove the lower PCB.
Step 10.
Disconnect connectors on the PCB. Remove the battery as well.
Step 11.
Disconnect connector on the PCB and remove the main camera.
Step 12.
Using a screwdriver (Phillips 1.5 mm PH000), unscrew 6 bolts in the PCB.
Step 13.
Remove the PCB.
Step 14.
Parts are in the frame of the display module.
If you have a question, ask us, and we will try to answer in as much detail as possible. If this article was helpful for you, please rate it.
Views
Likes
Share
Questions