Recommended tools
Heat gun
Screwdriver Phillips #000
Opening tool / Spudger
Tweezers
Disassembly/Repair of the mobile device HTC One E9s (HTC One E9s 2PNL100) with each step description and the required set of tools.
4414
Views
1
Likes
—
Share
18
Questions
Step 1.
Remove the tray
Using the key tool, open the SIM card tray and remove it.
âš Warning!
Do not push too hard this may cause damage.
Step 2.
Open the back cover
Open the back cover.
âš Warning!
For careful separation, we recommend using a heat gun. At the same time, it is necessary to heat carefully in order, not to damage the surface of the device.
Step 3.
Remove the coaxial cable
Disconnect connectors and remove coaxial cable.
Step 4.
Unscrew the screws
Using a screwdriver (Phillips 1.5 mm PH000), unscrew 16 bolts in the frame of the phone.
Step 5.
Remove the battery
Disconnect connector on the PCB and remove the battery.
Step 6.
Open the mid-frame
Pry and remove the middle frame.
Step 7.
Remove the loudspeaker
Pry and remove the buzzer (speaker).
Step 8.
Unscrew the screws
Using a screwdriver (Phillips 1.5 mm PH000), unscrew 2 bolts securing the charging port.
Step 9.
Disconnect the connector
Disconnect connector on the lower PCB and remove it.
Step 10.
Unscrew the screws
Using a screwdriver (Phillips 1.5 mm PH000), unscrew 2 bolts in the PCB.
Step 11.
Remove the vibration motor
Pry up the vibration motor.
Step 12.
Remove the sub-board
Overturn the board, disconnect the connectors from the inside and remove it.
Step 13.
In the display frame remained
Parts in the frame of the display module.
If you have a question, ask us, and we will try to answer in as much detail as possible. If this article was helpful for you, please rate it.
4414
Views
1
Likes
—
Share
18
Questions
Related Instructions
Related Reviews
Related Blog
Top instructions
Check our
Top HTC instructions most liked by readers
New instructions
Check our
New HTC brand instructions on vrm24.com
