Disassembly/Repair of the mobile device Apple iPhone 6 (iPhone 6 A1549, A1586, A1589, A1522, A1524, A1593) with each step description and the required set of tools.
Views
Likes
Share
Questions
Step 1.
Using the key tool, open the SIM card slot and remove it.
âš Warning!
Do not push too hard this may cause damage.
Step 2.
Using a screwdriver (Star Shape 0.8mm Pentalobe), unscrew the 2 bolts on the end of the phone.
Step 3.
Lift the display.
Step 4.
Using a screwdriver (Phillips 1.5 mm PH000), unscrew 2 bolts and remove the bracket holds the connectors.
Step 5.
Disconnect the battery connector.
âš Warning!
We strongly recommend disconnecting the connector to avoid a possible short circuit during disassembly.
Step 6.
Using a screwdriver (Phillips 1.5 mm PH000), unscrew 5 bolts and remove the bracket holds the connectors.
Step 7.
Disconnect the connectors on the printed circuit board and remove the display.
Step 8.
Using a screwdriver (Phillips 1.5 mm PH000), unscrew 2 bolts and remove the vibromotor.
Step 9.
Disconnect connectors on the PCB.
Step 10.
Using a screwdriver (Phillips 1.5 mm PH000), unscrew 2 bolts and remove the part with speaker (buzzer).
Step 11.
Using a screwdriver (Phillips 1.5 mm PH000), unscrew 2 bolts and remove the bracket holds the lightning / charging port.
Step 12.
Using a screwdriver (Phillips 1.5 mm PH000), unscrew 7 bolts.
Step 13.
Disconnect the flexible flat cable with a microphone, lightning/charging port, and headset connector.
Step 14.
Using a screwdriver (Phillips 1.5 mm PH000), unscrew 2 bolts and remove the bracket holds the connectors.
Step 15.
Using a screwdriver (Phillips 1.5 mm PH000), unscrew 5 bolts and remove the bracket.
Step 16.
Using a screwdriver (Phillips 1.5 mm PH000), unscrew 2 bolts and remove the bracket.
Step 17.
Using a screwdriver (Phillips 1.5 mm PH000), unscrew 2 bolts and remove the bracket holds the camera.
Step 18.
Using a screwdriver (Phillips 1.5 mm PH000), unscrew 1 bolt and remove the NFC antenna.
Step 19.
Disconnect connector on the PCB and remove the main camera.
Step 20.
Using a screwdriver (Phillips 1.5 mm PH000), unscrew 2 bolts and remove the bracket.
Step 21.
Using a screwdriver (Phillips 1.5 mm PH000), unscrew 2 bolts in the PCB.
Step 22.
Disconnect connectors on the PCB.
Step 23.
Remove the PCB.
Step 24.
Parts in the back cover (housing).
If you have a question, ask us, and we will try to answer in as much detail as possible. If this article was helpful for you, please rate it.
Views
Likes
Share
Questions